Stylized Ultra Flat Plane Fox (Step-by-step)

In keeping with my laziness, and trying something new, here's a step-by-step without explanation.  I am hoping that you all can figure out what each step photograph illustrates.  The important thing to remember is to make a stop cut first then either Pare or Slice to the stop cut.  And you can make several slices/paring cuts to get to the finished cut.

Personal safety gear is important too.  Carving glove and thumb guard.

You also may wish to use a piece of wood longer than the finished piece (2 1/2"), to provide additional holding space.

Start with a 1" x 1" x 2 1/2" piece of wood.  All carving is done on the corner.

STEP 1

STEP 2

STEP 3

STEP 4

STEP 5

STEP 6

STEP 7

STEP 8

STEP 9

STEP 10

STEP 11

STEP 12

STEP 13

You may wish to make some cuts on the back of the fox too relieve the center corner.